Pioneer VSX 1020 User Manual

Additional information 12
117
En
English
Français
Deutsch
Nederlands
Italiano
Español
USB interface
Symptoms Causes Remedies
The folders/files stored on
a USB memory device are
not displayed.
The folders/files are currently stored
in a region other than the FAT (File
Allocation Table) region.
Store the folders/files in the FAT region.
The number of levels in a folder is
more than 8.
Limit the maximum number of levels in a
folder to 8 (page 45).
There are more than 30 000 folders/
files stored in a USB memory device.
Limit the maximum number of folders/files
stored in a USB memory device to 30 000
(page 45).
The audio files are copyrighted. Copyrighted audio files stored on a USB
memory device cannot be played back
(page 45).
A USB memory device is
not recognized.
The USB memory device does not
support the mass storage class
specifications.
Try using a USB memory device compatible
with the mass storage class specifications.
Note that there are cases where even the
audio files stored on a USB memory device
compatible with the mass storage class
specifications are not played back on this
receiver (page 45).
Some formats of a USB memory
device, including NTFS, and HFS,
cannot be played back on this
receiver.
Check whether the format of your USB
memory device is either FAT 12, FAT 16 or
FAT 32. Note that the NTFS, and HFS
formats cannot be played back on this
receiver (page 45).
The USB memory device is not
connected properly.
Check the USB memory device connection,
then switch on this receiver (page 33).
A USB hub is currently being used. This receiver does not support a USB hub
(page 45).
This receiver recognizes the USB
memory device as a fraud.
Switch off and on again this receiver.
A USB memory device is
connected and displayed,
but the audio files stored
on the USB memory device
cannot be played back.
The file format cannot be properly
played back on this receiver.
See the list of file formats that can be played
back on this receiver (page 47).
Cannot detect USB
keyboard.
The USB keyboard is routed through
a USB hub.
This receiver is not compatible with USB
hubs. Plug the keyboard directly into the
receiver.
A PS2 keyboard is routed through a
PS2/USB connector.
PS2 keyboards cannot be used with this
receiver, even if routed through a PS2/USB
connector. Use a USB keyboard.
Keyboard is not a USB HID Class
device.
Some devices will not be detected. Use a
USB HID Class keyboard.
Cannot enter correct text
using the USB keyboard.
Keyboard is not US-international
layout.
Use a US-international layout keyboard.
NB: Some characters cannot be entered.
VSX-1020_UC.book 117 ページ ２０１０年１月７日 木曜日 午後６時０分

Pioneer VSX 1020 Specifications

General

Impedance	6 Ω
Frequency range	5 - 100000 Hz
Audio output channels	7.1 channels
Audio A/D Converter (ADC)	24-bit/96kHz
Signal-to-Noise Ratio (SNR)	100 dB
Total Harmonic Distortion (THD)	1 %
Audio system	Dolby TrueHD, DTS-HD Master Audio
Output power	140 W
Channels quantity	63 channels
Dimensions (WxDxH)	420 x 379 x 158 mm
Power requirements	AC 220 - 230 V, 50/60 Hz
HDMI ports quantity	7
Connectivity technology	Wired
Digital audio optical in	2
Product color	Black
Power consumption (standby)	0.6 W
Power consumption (typical)	245 W
Headphone connectivity	3.5 mm

Weight and Dimensions

Weight	10200 g