Using other functions08
72
En
Switching the speaker terminal
If you selected Speaker B in Speaker system
setting on page 100, you can switch between
speakers using the SPEAKERS button. If you
selected Normal(SB/FH), Normal(SB/FW),
Front Bi-Amp or ZONE 2, the button will
simply switch your main speaker terminal on or
off. The options below are for the Speaker B
setting only.
1
•Use
SPEAKERS
on the front panel to
select a speaker terminal setting.
As mentioned above, if you have selected
Normal(SB/FH) or Normal(SB/FW), the
button will simply switch your main speaker
terminal (A) on or off.
Press repeatedly to choose a speaker terminal
option:
• SPA – Sound is output from A-speaker
terminal (up to 7 channels (including
surround back channels), depending on
the source).
• SPB – Sound is output from the two
speakers connected to B-speaker terminal.
Multichannel sources will not be heard.
• SPAB – Sound is output from A-speaker
terminal (up to 5 channels, depending on
the source), the two speakers in B-speaker
terminal, and the subwoofer. The sound
from B-speaker terminal will be the same
as the sound from A-speaker terminal
(multichannel sources will be downmixed
to 2 channels).
• SP (off) – No sound is output from the
speakers.
Using the MULTI-ZONE controls
The following steps use the front panel controls
to adjust the sub zone volume and select
sources. See MULTI-ZONE remote controls on
page 73.
1 Press
MULTI-ZONE ON/OFF
on the front
panel.
Each press selects a MULTI-ZONE option:
• ZONE 2 ON – Switches the MULTI-ZONE
feature on
• MULTI ZONE OFF – Switches the MULTI-
ZONE feature off
The MULTI-ZONE indicator lights when the
MULTI-ZONE control has been switched ON.
2 Press
MULTI-ZONE CONTROL
on the
front panel.
• When the receiver is on,
2
make sure that
any operations for the sub zone are done
while ZONE 2 shows in the display. If this is
not showing, the front panel controls affect
the main zone only.
3Use the
INPUT SELECTOR
dial to select
the source for the sub zone.
For example, ZONE 2 CD-R sends the source
connected to the CD-R inputs to the sub room
(ZONE 2).
•If you select TUNER, you can use the tuner
controls to select a preset station (see
Saving station presets on page 48 if you’re
unsure how to do this).
3
4 When
Speaker System
is set to
ZONE 2
,
use the
MASTER VOLUME
dial to adjust the
volume for the sub zone.
4
1 • The subwoofer output depends on the settings you made in Manual speaker setup on page 99. However, if SPB is
selected above, no sound is heard from the subwoofer (the LFE channel is not downmixed).
• All speaker systems (except Speaker B connections) are switched off when headphones are connected.
2 If the receiver is in standby, the display is dimmed, and ZONE 2 DVD for example shows in the display.
3 The tuner cannot be tuned to more than one station at a time. Therefore, changing the station in one zone also
changes the station in the other zone. Please be careful not to change stations when recording a radio broadcast.
4 The volume levels of the main and sub zone are independent.
VSX-1020_UC.book 72 ページ ２０１０年１月７日 木曜日 午後６時０分
To Next Page
Loading...
Need help?
General
Weight and Dimensions
