Controlling the rest of your system09
78
En
3 Point the two remote controls towards
each other, then press the button that will be
doing the learning on this receiver’s remote
control.
The LED blinks once and flashes continuously.
• The remote controls should be 3 cm (1 inch)
apart.
4 Press the corresponding button on the
other remote control that is sending (teaching)
the signal to this receiver’s remote control.
If the LED lights for one second, the setting has
been successfully completed.
1
5 To program additional signals for the
current component repeat steps 3 and 4.
To program signals for another component,
exit and repeat steps 2 through 4.
6Press
R.SETUP
to exit the programming
mode.
Erasing one of the remote
control button settings
This erases one of the buttons you have
programmed and restores the button to the
factory default.
1 Press and hold the
R.SETUP
, press “7” for
three seconds.
The LED flashes continuously.
• To cancel the preset setup mode press
R.SETUP.
2 Press the input function button
corresponding to the command to be erased,
then press
ENTER
.
The LED flash once.
3 Press and hold the button to be erased for
three seconds.
If the LED lights for one second, the erasing
has been successfully completed.
4 Repeat step 3 to erase other buttons.
5 Press
R.SETUP
to exit the erasing mode.
1 • Note that interference from TVs or other devices will sometimes result in the remote control learning the wrong
signal.
• Some commands from other remote controls cannot be learned, but in most cases the remotes just need to be
moved closer together or farther apart.
• If the LED flashes for five seconds, it means the memory is full. See Erasing all learnt settings that are in one input
function on page 79 to erase a programmed button you’re not using to free up more memory (note that some signals
may take more memory than others).
3 cm
(1 inch)
This receiver’s
remote control
Other remote
control
VSX-1020_UC.book 78 ページ ２０１０年１月７日 木曜日 午後６時０分
To Next Page
Loading...
Need help?
General
Weight and Dimensions
