6.7
CLUTCHING
6
13. Reinstall drive belt noting direction of rotation. If a new belt
is installed, install so numbers can be easily read.
14. Replace PVT outer clutch cover rubber gasket.
15. Reinstall PVT outer clutch cover and secure with screws.
Torque to 45-50 in. lbs. (5-5.6 Nm).
16. Install the PVT cover outlet duct and tighten the clamps.
DRIVE BELT
Belt Removal
1. Remove outer PVT cover as described in PVT
Disassembly.
2. Mark the drive belt direction of rotation so that it can be
installed in the same direction.
NOTE: Belt is normally positioned so that part
numbers are easily read.
3. To remove drive belt, put transmission in gear, apply brake,
pull upward and rearward on belt to open driven clutch
sheaves, pull out and down on belt to slip over the driven
clutch outer sheave.
Inner Cover Bolt Torque (Rear):
12 ft. lbs. (16.6 Nm)
Outer Cover Bolt Torque:
45-50 in.lbs. (5-5.6 Nm)
Driven Clutch Retaining Bolt Torque:
17 ft. lbs. (23.5 Nm)
Drive Clutch Retaining Bolt Torque:
47 ft. lbs. (64 Nm)
To Next Page
Loading...
Need help?
General
