7.3
FINAL DRIVE
7
SPECIAL TOOLS
TORQUE SPECIFICATIONS
Wheel, Hub, and Spindle Torque Table
FRONT HUB
Hub Removal / Inspection
1. Elevate front end and safely support machine under
footrest / frame area.
2. Check bearings for side play by grasping the tire / wheel
firmly and checking for movement. Grasp the top and
bottom of the tire. The tire should rotate smoothly without
binding or rough spots.
3. Remove wheel nuts, washers, and wheel.
4. Remove the two brake caliper attaching bolts.
CAUTION: Do not hang the caliper by the brake line. Use
wire to hang the caliper to prevent possible damage to the
brake line.
PART NUMBER TOOL DESCRIPTION
2872608 Roller Pin Removal Tool
8700226 CV Boot Clamp Pliers
PU-48951 Axle Boot Clamp Tool
ITEM NUT TYPE SPECIFICATION
Aluminum Wheels
(Cast)
Lug Nut (1) 90 ft. lbs. (122 Nm)
Steel Wheels
(Black / Camo)
Flange Nut (2) 35 ft. lbs. (47 Nm)
Front Spindle Nut - 70 ft. lbs. (95 Nm)
Rear & Middle
Hub Retaining Nut
- 110 ft. lbs. (150 Nm)
Steel Wheel
(Standard Models)
35 ft. lbs. (47 Nm)
Aluminum Wheel
(LE Models)
90 ft. lbs. (122 Nm)
#1
#2
CAUTION
Serious injury may result if machine tips or falls.
Be sure machine is secure before beginning this
service procedure. Wear eye protection when
removing bearings and seals.
To Next Page
Loading...
Need help?
General
