3.68
9924707 - 2013–2014 RZR 800 Service Manual
© Copyright 2013 Polaris Sales Inc.
7. Install rockers. Be sure that tab of fulcrum (F) is
seated in head stand-off. Torque bolts to
specification.
Rocker Arm Bolt:
22 ± 2 ft-lbs (30 ± 3 Nm)
8. Install breather reed (G) into rocker cover (H). Lightly
apply black RTV sealant to outer edges of breather
reed. The reed has a tab and will assemble one-way
only. Torque breather bolts to specification.
Breather Bolts:
20 ± 5 in-lbs (2.5± 0.55 Nm)
NOTE: When applying RTV, do not get any RTV
inside the reed assembly.
9. Place a new seal (I) into the bottom of the cover. Be
sure the seal is seated into the cover properly.
IMPORTANT: Before assembly, clean the bolts
and bolt holes with Loctite Primer N
(commercially available) to remove any debris.
10. Install rocker cover. Torque bolts in sequence to
specification.
Rocker Cover Bolts:
84 ± 8 in-lbs (9.5 ± 0.9 Nm)
ENGINE
To Next Page
Loading...
Need help?
General
