7
7.23
9924707 - 2013–2014 RZR 800 Service Manual
© Copyright 2013 Polaris Sales Inc.
7. Inspect the roll cage assembly for cracks or
excessive wear. If damaged, replace the roll cage
assembly.
Gearcase Removal
1. Stop engine and place gear selector in Park.
2. Refer to “FRONT DRIVE SHAFT - Drive Shaft
Removal” and remove both front drive shafts from
the front gearcase.
3. Remove the propshaft (see “PROPSHAFT
SERVICE”).
4. Disconnect the wire harness above the front
gearcase and remove the harness from the retaining
dart.
5. Remove the vent line from the front gearcase.
6. Remove the (4) bolts securing the front gearcase to
frame.
7. Remove the gearcase from the front LH wheel well
area and slide it between the upper and lower A-arm.
FINAL DRIVE
To Next Page
Loading...
Need help?
General
