5.46
9924707 - 2013–2014 RZR 800 Service Manual
© Copyright 2013 Polaris Sales Inc.
4. Remove the stabilizer bar and bracket from the
frame as an assembly.
5. Inspect the stabilizer bar for straightness. Inspect the
bushings and replace if needed.
6. Inspect the rubber bushings on the linkage rod and
replace if needed.
7. Reverse the procedure for installation. Torque the
stabilizer bolts to specification.
Stabilizer Mounting Bolts:
18 ft-lbs (24 Nm)
REAR STABILIZER BAR (RZR S / RZR
4)
Removal / Installation
1. Remove the exhaust pipe and exhaust silencer from
the vehicle.
NOTE: The exhaust silencer can be removed
through the side of the vehicle after the exhaust
pipe is detached from the header pipe.
2. Remove the fastener retaining the stabilizer bar to
the linkage on each side of the vehicle.
3. Remove the (4) fasteners retaining the stabilizer bar
to the bracket.
BODY / STEERING / SUSPENSION
To Next Page
Loading...
Need help?
General
