5
5.33
9924707 - 2013–2014 RZR 800 Service Manual
© Copyright 2013 Polaris Sales Inc.
6. Torque the (4) mount bracket nuts to specification.
Power Steering Unit Mount Bracket Nuts:
17 ft-lbs (23 Nm)
7. Reinstall the throttle pedal return spring.
8. Proceed to “Upper Steering Shaft Installation (EPS
Models)” to complete the installation procedure.
Upper Steering Shaft Installation (EPS
Models)
IMPORTANT: If steering wheel was removed, follow
this procedure to ensure the upper steering shaft is
properly positioned on the power steering stub
shaft.
CAUTION
Striking the steering wheel or steering shaft can
permanently damage the EPS unit and cause a Power
Steering Fault.
NOTE: Be sure upper steering shaft hardware is
positioned correctly (see “Exploded View’).
1. Install the upper steering shaft and align the skip-
tooth spline on the power steering stub shaft with the
opening in the upper steering shaft.
2. Install pivot tube and torque fasteners to
specification.
Pivot Tube Fasteners:
23 ft-lbs (31 Nm)
3. Install tilt shock and torque fastener to specification.
Upper Tilt Shock Fastener:
7 ft-lbs (10 Nm)
BODY / STEERING / SUSPENSION
To Next Page
Loading...
Need help?
General
