7
7.31
9924707 - 2013–2014 RZR 800 Service Manual
© Copyright 2013 Polaris Sales Inc.
REAR BEARING CARRIER
Bearing Carrier Inspection / Removal
1. Elevate rear of vehicle and safely support machine
under the frame area.
CAUTION
Serious injury may result if machine tips or falls. Be
sure machine is secure before beginning this service
procedure. Wear eye protection when removing
bearings and seals.
2. Check bearings for side play by grasping the top and
bottom of the tire firmly and checking for movement.
The tire should rotate smoothly without binding or
rough spots.
3. Remove the (4) wheel nuts and remove rear wheel.
4. Remove the cotter pin and loosen the rear wheel hub
castle nut. Remove the nut, and (2) cone washers
from the rear wheel hub assembly.
5. Remove the two brake caliper mounting bolts.
CAUTION: Do not hang caliper by the brake line.
Use wire to hang caliper to prevent damage to brake
line.
6. Remove the rear wheel hub assembly.
7. Remove the bolts that attach the rear bearing carrier
to the upper and lower A-arms.
FINAL DRIVE
To Next Page
Loading...
Need help?
General
