Polaris RZR 800 2013 User Manual

7
7.33
9924707 - 2013–2014 RZR 800 Service Manual
© Copyright 2013 Polaris Sales Inc.
7. Apply Loctite
®
603™ retaining compound to the
outer circumference of the new bearing race and
carefully press the new bearing into the bearing
carrier housing.
NOTE: Use care to not allow any of the Loctite
®
compound to get in the bearing.
8. Wipe the housing clean of any excess compound
and install the snap ring.
Bearing Carrier Bushing Replacement
Check bearing carrier bushings and pivot tubes for
excessive wear or damage. If replacement is required,
slide pivot tubes out and remove bushings with a drift
punch. Install new bushings by pressing them into the
bearing carrier.
Bearing Carrier Installation
1. Install drive shaft axle through the backside of the
bearing carrier. Be sure bushings and pivot tubes are
installed.
FINAL DRIVE

Polaris RZR 800 2013 Specifications

General

Brand	Polaris
Model	RZR 800 2013
Category	Offroad Vehicle
Language	English