Polaris RZR 800 2013 User Manual

4.36
9924707 - 2013–2014 RZR 800 Service Manual
© Copyright 2013 Polaris Sales Inc.
TPS Resistance Tests
The TPS is a non-serviceable item. If it is faulty, it must
be replaced. It can be tested using the following method:
With the test leads connected and the meter set to the
ohms scale, observe the reading at the following pin
locations of the TPS:
TPS Resistance Readings
Pins
Throttle
Position
Resistance
2 -
GND
——— ∞
1 - 2 Closed
4 kΩ - 5 kΩ (reference)
1 - 2
Open
1150 Ω - 1250 Ω
(reference)
1 - 3
———
4 kΩ - 6 kΩ
TPS Tester / Regulator
The TPS reading can be checked by using the Throttle
Position Sensor (TPS) Tester (2201519-A).
Set-up the TPS Tester Wire Harness (PU-47466) and
TPS Tester Regulator (547927) according to the
instructions that accompanied the tester. Make sure the 9
Volt battery is new.
Verify TPS Tester Reference Voltage
A 5 volt reference voltage from the TPS Tester harness is
required for the TPS test to be accurate. Refer to the
instructions provided with the TPS Tester (2201519-A) or
follow the bullet point steps below to check reference
voltage.
Reference Voltage Test:
• Insert black voltmeter probe into the test port as
shown.
ELECTRONIC FUEL INJECTION

Polaris RZR 800 2013 Specifications

General

Brand	Polaris
Model	RZR 800 2013
Category	Offroad Vehicle
Language	English