10.8
9924707 - 2013–2014 RZR 800 Service Manual
© Copyright 2013 Polaris Sales Inc.
Transmission (Gear Position) Switch
1. Disconnect the transmission switch harness by lifting
the connector lock and pulling on the connector. Do
not pull on the wiring.
2. Test the transmission switch continuity readings for
each gear position and compare to the specification
table below.
Gear Position
Resistance Value
when measured at
terminals A and B
HIGH 620 Ω
LOW 300 Ω
NEU
160 Ω
REV 75 Ω
PARK
24 Ω
Throttle Release Switch (TRS)
TRS System Operation
This vehicle is equipped with a throttle release switch
(TRS) to detect when the throttle pedal has returned to
the rest position.
NOTE: The throttle pedal lever is designed to have a
few degrees of freeplay prior to engaging the throttle
arm that pulls the throttle cable.
With the pedal in the rest position, the "blade" at the top
of the pedal is almost out of the TRS switch slot,
exposing the TRS switch to magnetic force in the
opposite side of the sensor. When the pedal is
depressed, the throttle pedal blade blocks the magnetic
force from the TRS switch.
TRS Location
The TRS switch (A) is located in the drivers foot control
area, mounted on the top of the throttle pedal assembly.
TRS Testing
The TRS is a serviceable item and can be tested using
Digital Wrench® or an Ohm meter.
1. Disconnect the TRS harness connection located by
the fuse box.
ELECTRICAL
To Next Page
Loading...
Need help?
General
