10
10.9
9924707 - 2013–2014 RZR 800 Service Manual
© Copyright 2013 Polaris Sales Inc.
2. With the throttle pedal “at rest”, connect an
ohmmeter between the TRS pin terminals. A
resistance value of 2.15k Ohms +/- 5% at room
temperature should be obtained. If the sensor reading
is more than 2.26k Ohms, it is out of specification
and needs to be replaced.
3. With the throttle pedal fully depressed, connect an
ohmmeter between the TRS pin terminals. A
resistance value of 6.8k Ohms +/- 5% at room
temperature should be obtained. If the sensor reading
is less than 6.46k Ohms, it is out of specification and
needs to be replaced.
Throttle
“At Rest”
Throttle
Fully Depressed
2.15k Ohms +/-5% 6.8k Ohms +/-5%
Replace sensor if reading
is more than:
2.26k Ohms
Replace sensor if reading
is less than:
6.46k Ohms
TRS Removal
1. Remove the drivers seat and disconnect the negative
(-) battery cable.
2. Remove the (2) bolts securing the TRS to the throttle
pedal assembly.
3. Remove the TRS from the vehicle.
TRS Installation / Adjustment
1. Place the TRS on throttle pedal assembly and
loosely install the (2) fasteners.
2. The TRS mounting holes are oblonged to allow for
switch alignment. Visually center the TRS slot with
the throttle pedal blade (C). It may be necessary to
manually cycle the throttle pedal to verity the center
alignment.
3. Torque the (2) mounting bolts to specification and
connect the TRS harness connection.
TRS Retaining Nuts:
7 ft-lbs (10 Nm)
4. Manually cycle the throttle pedal to verify the throttle
pedal blade is centered in the TRS slot.
5. Connect the negative (-) battery cable and install the
drivers seat.
ELECTRICAL
To Next Page
Loading...
Need help?
General
