10.18
9924707 - 2013–2014 RZR 800 Service Manual
© Copyright 2013 Polaris Sales Inc.
6. To exit the diagnostic mode, press and hold the
MODE button or turn the ignition key OFF once the
codes are recorded.
NOTE: If there is a diagnostic problem with the
power steering system, the power steering MIL
will illuminate and blink in place of the check
engine MIL.
Instrument Cluster Pinouts
Function
PIN
CAN High
1
CAN Low 2
Switched Power (Vdc)
3
Constant Power (Vdc)
4
Ground
5
High Beam Input
8
Fuel Level Sensor 11
International Models Only
Turn Signal Input, LH
6
Turn Signal Input, RH
7
Instrument Cluster Removal
NOTE: Do not allow alcohol or petroleum products
to come in contact with the instrument cluster lens.
1. Disconnect the wire harness connector from the
back side of the instrument cluster.
2. Push instrument cluster out from back side of the
dash while securely holding the dash and rubber
mount.
NOTE: Do not remove the rubber mount from
the dash panel. Only remove the rubber mount if
necessary. The bezel is a snap-on assembly and
is a serviceable part.
Instrument Cluster Installation
1. Spray a soap and water mixture onto outer surface
area of instrument cluster. This will help the
instrument cluster slide into the rubber mount easily.
2. Be sure the rubber mount inside the dash is fully
installed and that the indexing key on the rubber
mount is lined up with the keyway in the dash.
3. Hold dash securely and insert the instrument cluster
into the dash. Twist the instrument cluster gently in a
clockwise motion to properly seat the instrument
cluster into the rubber mount. Apply pressure on the
bezel while pressing down on the instrument cluster.
ELECTRICAL
To Next Page
Loading...
Need help?
General
