10
10.7
9924707 - 2013–2014 RZR 800 Service Manual
© Copyright 2013 Polaris Sales Inc.
Turn Signal Switch (INT’L)
1. Disconnect the Turn Signal switch harness by
depressing the connector locks and pulling on the
connector. Do not pull on the wiring.
2. Test between the 5 sets of outputs (HI BEAM / LO
BEAM / L-TURN / R-TURN / HORN). If any of the
tests fail, replace the switch assembly.
Hazard Switch (INT’L)
1. Disconnect the harness from the Hazard switch.
2. Test between the outputs (ON / NONE / OFF). If any
of the tests fail, replace the switch assembly.
• Move switch to ON. There should be continuity
between switch pins 2 and 3.
• Move switch to NONE / OFF. There should be no
continuity between switch legs or pins.
ELECTRICAL
To Next Page
Loading...
Need help?
General
