8
8.13
9924707 - 2013–2014 RZR 800 Service Manual
© Copyright 2013 Polaris Sales Inc.
29. Install the transfer case cover. Align the dowels (#1,
#7) and insert the cover screws (note position of the
longest screw #4). Torque the screws evenly to
specification in sequence as shown.
Transfer Case Cover Screws:
23-27 ft-lbs (31-37 Nm)
30. Place a 23 mm, 12 point socket over the splines of
the output shaft. Attach an Inch Pound (in-lbs) dial
indicator torque wrench to the socket. Check the
intermediate pinion shaft assembly bearing rolling
preload by rotating the output shaft both clockwise
and counter-clockwise.
Intermediate Shaft Rolling:
17-22 in-lbs (1.9-2.48 Nm)
31. A) If the torque required to rotate the output shaft is
out of specification, repeat steps 24-30 until within
specification.
B) If the torque required to rotate the output shaft is
within specification, no adjustment is needed and the
transfer case reassembly is complete.
TRANSMISSION
To Next Page
Loading...
Need help?
General
