8
8.17
9924707 - 2013–2014 RZR 800 Service Manual
© Copyright 2013 Polaris Sales Inc.
12. Pull back fully on gear selector arm to bring shift
collar up and disengage the shift collar from the
clutch yoke. Lifting on the clutch shaft may aid in shift
collar removal.
13. Inspect the inner and outer gear teeth and splines on
both ends of the shift collar for excessive wear or
damage.
14. Remove the retaining rings from each end of the shift
collar.
15. Remove the wave spring and ball bearing cage
assembly from the shift collar as shown.
16. Inspect the ball bearing channels on both ends of the
shift collar for excessive wear or damage.
17. Remove the sliding shoes from the clutch yoke.
18. Remove the clutch shaft assembly from the housing.
The forward gear assembly and bearings will remain
on the shaft upon removal.
19. Disassemble the clutch shaft as needed by removing
both retaining rings and separating the high and low
gears from the clutch shaft. Inspect all parts for wear
or damage and replace as required.
20. Remove the set screw retaining the pivot pin.
TRANSMISSION
To Next Page
Loading...
Need help?
General
