3.20
9924707 - 2013–2014 RZR 800 Service Manual
© Copyright 2013 Polaris Sales Inc.
11. Remove the (2) push rivets and remove the intake
box from the vehicle.
12. Elevate the rear of the vehicle off the ground using a
suitable ATV lift and remove both rear wheels.
13. Remove all exhaust components from vehicle and
engine.
14. Loosen the hose clamp attaching the outlet duct to
the PVT cover. Leave the duct attached to the upper
frame support.
15. Remove the (8) screws that retain the PVT cover and
remove cover.
16. Remove the high tension leads from the spark plugs
and disconnect the ignition coil harness.
IMPORTANT: Mark or note which ignition coil
wire goes to which cylinder and ignition coil
post. The engine will misfire if the spark plug
wires are installed incorrectly. The spark plug
wires are marked with PTO and MAG from the
factory and should be installed to the
corresponding cylinder and ignition coil post.
17. Remove the vent lines from the upper bolt-in frame
brace and plug vent lines to prevent fluid leakage
during removal.
18. Remove the (6) fasteners retaining the upper bolt-in
frame brace and remove it from the vehicle with the
ignition coil and PVT duct attached.
ENGINE
To Next Page
Loading...
Need help?
General
