Using Job Preset in Connect Copy
153
3
Using Job Preset in Connect Copy
You can make settings for the next Connect Copy job when the current job is still
in progress on the main machine. When the current job finishes, the next job be-
gins automatically.
A On the main machine, confirm that “Press [New Job] to make reserva-
tion.” is displayed, and then press [New Job].
B Confirm that “Ready” is displayed, and then press [Connect Copy].
C Place the originals in the main machine.
D Confirm that “Ready” is displayed, and then make settings for the job.
E Press the {Start} key on the main machine.
Press the {q} key when you have finished scanning all the originals.
When placing multiple originals in the ADF, wait till the first original has
been fed before placing the next.
Scanning begins. As soon as the current job is finished, the next job starts automatically.
Note
❒ You can preset a maximum of eight jobs.
❒ Preset jobs in Connect Copy mode can only be changed when the main ma-
chine has finished scanning the originals.
❒ Preset jobs in Connect Copy mode can only be changed when copying has
yet to begin on either machine.
To Next Page
Loading...
Need help?
General
