Copying
36
2
Copying from the Bypass Tray
The bypass tray allows you to copy non-standard paper.
Important
❒ The bypass tray is set to [1 Sided→2 Sided] by default. When copying from the
bypass tray, select [1 Sided→1 Sided] in [Dup./Combine/Series]. You can change
the initial settings. See “Programming Defaults in Initial Display”.
❒ Paper has a vertical length of 100-305 mm (3.9-12 inch) and a horizontal
length of 139.7-600 mm (5.5-23.6 inch) can be copied from the bypass tray.
❒ The machine can automatically detect the following sizes as standard size
copy paper:
•Metric version: A3L, A4L, A5L
• Inch version: A3L, 11" × 17"L, 8
1
/
2
" × 14"L, 5
1
/
2
" × 8
1
/
2
"L
❒ If you want to use the size of paper other than the above, be sure to specify
the size.
❒ When copying on OHP transparencies or paper heavier than 105 g/m
2
(about
27.9 lb.), you need to specify the type and size of paper with “Special Original”.
❒ The maximum number of sheets you can load into the bypass tray depend on
paper type. The number should not exceed the upper limit.
❒ When paper larger than 433 mm (17.1 inch) in size is used, the paper may be-
come wrinkled, may not be fed into the machine, or may cause paper jams.
❒ When copying onto special paper such as adhesive labels, always select “Face
Up”. If you select “Face Down”, a paper misfeed may occur.
❒ If you place originals on the exposure glass and want the copies to be deliv-
ered face down, select “Face Down” for both ”Copy Eject Face Method in
Glass Mode” and “Copy Eject Face Method in Bypass Mode” of User Tools.
❖ [Bypass Tray Usage]
Press [Bypass Tray Usage] to display a description on using the bypass tray.
To Next Page
Loading...
Need help?
General
