"authfree" Command
If [Simple (Limitation)] is selected under printer job authentication, the telnet authfree command can be
used to specify exceptions to the printer job authentication.
The default user name for logging into telnet is "admin". The password is not configured by default. For
details about logging into and using telnet, see "Remote Maintenance Using telnet", Connecting the
Machine/ System Settings.
View settings
msh> authfree
If print job authentication exclusion is not specified, authentication exclusion control is not
displayed.
IPv4 address settings
msh> authfree "ID" range "start-address" "end-address"
IPv6 address settings
msh> authfree "ID" range6 "start-address" "end-address"
IPv6 address mask settings
msh> authfree "ID" mask6 "base-address" "masklen"
Parallel/USB settings
msh> authfree [parallel|usb] [on|off]
• To exclude parallel and USB connections from printer job authentication, set this to "on". The
default setting is "off".
• Always specify either "parallel" or "USB".
"parallel" can be specified when an optional IEEE 1284 interface board is installed.
Authentication exclusion control initialization
msh> authfree flush
• In both IPv4 and IPv6 environments, up to five access ranges can be registered and selected.
2. Configuring User Authentication
66
To Next Page
Loading...
Need help?
General
