Restricting a Customer Engineer Operation
You can restrict the customer engineer's access to the service mode.
Service mode is used by a customer engineer for inspection or repair. If you set "Service Mode Lock" to
[On], service mode cannot be used unless the machine administrator logs on to the machine and
cancels the service mode lock to allow a customer engineer to operate the machine for inspection and
repair. This ensures that the inspection and repair are done under the supervision of the machine
administrator.
1. Log in as the machine administrator from the control panel.
2. Press [System Settings].
3. Press [Administrator Tools].
4. Press [ Next] twice.
5. Press [Service Mode Lock].
6. Press [On], and then press [OK].
7. Press [Yes].
8. Log out.
Restricting a Customer Engineer Operation
267
To Next Page
Loading...
Need help?
General
