• B5 (width: 182 mm; length: 257 mm)–SRA4 (width: 225 mm; length: 320 mm) of Paper
Weight 8
• Carbonless paper of Paper Weight 2 or less
1. Check that paper in the paper tray is not being used, and then pull the tray carefully out
until it stops.
2. Take out the small tab end fence from the pocket on the right-hand side of the paper
source tray.
3. Set the side fences to the size of the paper to be loaded, and then load paper into the
tray.
4. Attach the small tab end fence, and then align the end fence gently against the paper you
loaded while pressing the release button of the end fence.
5. Push the paper tray fully in until it clicks.
• Replace the small tab end fence after use.
6. Paper Specifications and Adding Paper
182
To Next Page
Loading...
Need help?
General
