• Be sure to disconnect the power cord from the wall outlet at least once a year and check for the
following:
• The power cord's inner wires are exposed, broken, etc.
• The power cord's coating has a crack or dent.
• When bending the power cord, the power turns off and on.
• Part of the power cord becomes hot.
• The power cord is damaged.
• If any of the above conditions exist, do not use the power cord and consult your dealer or
service representative. Use of the power cord could result in fire or electric shock.
• Be sure to disconnect the plug from the wall outlet and clean the prongs and the area around
the prongs at least once a year. Allowing dust to build up on the plug constitutes a fire hazard.
• Turn off the main power switch before unplugging the power cord. See page 91 "Turning On/Off
the Power".
• After cleaning the power cord plug, make sure that the power cord is connected to the machine
firmly, and then connect the plug to the wall outlet.
Cleaning the TIM-Mag Unit
• Before cleaning the TIM-Mag unit, turn off the machine and wait for a while to
allow the machine to cool down fully.
Not doing so could result in burns.
Cleaning the Unit
Wipe the surface of the glass, shading correction plate, and glass scale of the revolver using the
cleaning cloth provided with the machine. Use a soft dry cloth to wipe the counter roller of the
revolver.
1. Open the front cover.
Maintaining Your Machine
537
To Next Page
Loading...
Need help?
General
