33
Try Out the Various Sounds
How to change the level of a part using MIDI messages
<Example> Setting the level of Part 1 to 110
MIDI CH = 01
CC#07 110
■ Adjusting the Pan (Stereo Position)
Pan sets the stereo position of the sound when a stereo playback system is used. For
example, the drum set and bass might be placed in the center, the guitar at right, and
the keyboard at left.
1
Make sure that the Part Basic screen is selected.
2
Press [EDIT].
3
Press [EDIT] ([F2]).
4
Press VAR. [ ] or INST [ ] to move the cursor to Part Pan.
fig.3-8
5
Rotate the [VALUE] knob, or press [DEC] or [INC] to set the pan.
To place a sound in the center, set the Pan value to 0. As the L-value increases the
sound will be placed further left, and as the R-value increases the sound will be
placed further right. You can specify a value between L63 and R63, and center is 0.
If you continue pressing [DEC], Rnd (random) will be selected, and each note will
be placed at a random stereo position.
You can input the part level
as a value of 0 – 127.
The control numbers of the
control changes are
indicated as CC#. Control
Change (p.149)
Part Basic screen (p.29)
Part Pan (p.54)
A faster change in the value
can be obtained if you hold
down the [INC] (or [DEC])
utton while you press its
counterpart, the [DEC] (or
[INC]) button.
For some Instruments,
small amounts of leakage
may be heard from the
opposite speaker even
when pan has been set fully
left or right.
If you are listening in
monaural, pan settings will
have no effect.
To Next Page
Loading...
Need help?
General
