216
Appendices
Insertion Effect List
●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●
<Example of effect types and effect parameters>
Parameter Setting Value Value (Hex.) MSB/LSB (H)
01 : Stereo-EQ 01 00
Low Freq 200/400 00/01 03
• The MSB/LSB column shows the following ** portion of the Exclusive
message. (Hexadecimal notation) (p.237)
For Effect Type (Data section)
F0 41 dev 42 12 40 03 00 ** ** sum F7
For Effect Parameter (LSB part of address)
F0 41 dev 42 12 40 03 ** data sum F7
(dev: device ID, sum: checksum)
• Parameters that have a + in front of their name can be modified by Effect
Control 1 (EFX C.Src1). (p.129)
• Parameters that have a # in front of their name can be modified by Effect
Control 2 (EFX C.Src2). (p.129)
• Values shown in boldface in the Setting Value column are the default value
of the parameter.
• The correspondence between setting values and hexadecimal values for
items in the Value column indicated with * is shown in Effect Parameter
Value Conversion Table (p. 224).
*1: Pre Delay Time *6: Rate 1 *11: LPF
*2: Delay Time 1 *7: Rate 2 *12: Manual
*3: Delay Time 2 *8: HF Damp *13: Azimuth
*4: Delay Time 3 *9: Cutoff Freq *14: Accl
*5: Delay Time 4 *10: EQ Freq
●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●
❍ Effects that modify the tone (filter type)
Parameter Setting Value Value (Hex.) MSB/LSB (H)
00 : Thru 00 00
01 : Stereo-EQ 01 00
Low Freq 200/400 00/01 03
Low Gain -12–+5–+12 34–4C 04
Hi Freq 4k/8k 00/01 05
Hi Gain -12–+12 34–4C 06
M1 Freq 200–1.6k–6.3k *10 07
M1 Q 0.5/1.0/2.0/4.0/9.0 00/01/02/03/04 08
M1 Gain -12–+8–+12 34–4C 09
M2 Freq 200–1k–6.3k *10 0A
M2 Q 0.5/1.0/2.0/4.0/9.0 00/01/02/03/04 0B
M2 Gain -12–-8–+12 34–4C 0C
+ Level 0–127 00–7F 16
02 : Spectrum 01 01
Band 1 -12–-4–+12 34–4C 03
Band 2 -12–+1–+12 34–4C 04
Band 3 -12–+3–+12 34–4C 05
Band 4 -12–+6–+12 34–4C 06
Band 5 -12–+2–+12 34–4C 07
Band 6 -12–-1–+12 34–4C 08
Band 7 -12–-4–+12 34–4C 09
Band 8 -12–-5–+12 34–4C 0A
Width 0.5/1.0/2.0/4.0/9.0 00/01/02/03/04 0B
+ Pan L63–0–R63 00–7F 15
# Level 0–127 00–7F 16
Parameter Setting Value Value (Hex.) MSB/LSB (H)
03 : Enhancer 01 02
+ Sens 0–64–127 00–7F 03
# Mix 0–127 00–7F 04
Low Gain -12–+3–+12 34–4C 13
Hi Gain -12–0–+12 34–4C 14
Level 0–127 00–7F 16
04 : Humanizer 01 03
Drive 0–48–127 00–7F 03
Drive Sw Off/On 00/01 04
+ Vowel a/i/u/e/o 00/01/02/03/04 05
Accel 0–15 *14 06
Low Gain -12–0–+12 34–4C 13
Hi Gain -12–0–+12 34–4C 14
Pan L63–0–R63 00–7F 15
# Level 0–127 00–7F 16
❍
Effects that distort the sound (distortion type)
05 : Overdrive 01 10
+ Drive 0–48–127 00–7F 03
Amp Type Small/BltIn/2-Stk/3-Stk 00/01/02/03 04
Amp Sw Off/On 00/01 05
Low Gain -12–0–+12 34–4C 13
Hi Gain -12–0–+12 34–4C 14
# Pan L63–0–R63 00–7F 15
Level 0–96–127 00–7F 16
06 : Distortion 01 11
+ Drive 0–76–127 00–7F 03
Amp Type Small/BltIn/2-Stk/3-Stk 00/01/02/03 04
Amp Sw Off/On 00/01 05
Low Gain -12–0–+12 34–4C 13
Hi Gain -12–-8–+12 34–4C 14
# Pan L63–0–R63 00–7F 15
Level 0–84–127 00–7F 16
❍ Effects that modulate the sound
(modulation type)
07 : Phaser 01 20
+ Manual 100–620–8k *12 03
# Rate 0.05–0.85–10.0 *6 04
Depth 0–64–127 00–7F 05
Reso 0–16–127 00–7F 06
Mix 0–127 00–7F 07
Low Gain -12–0–+12 34–4C 13
Hi Gain -12–0–+12 34–4C 14
Level 0–104–127 00–7F 16
08 : Auto Wah 01 21
Fil Type LPF/BPF 00/01 03
Sens 0–127 00–7F 04
+ Manual 0–68–127 00–7F 05
Peak 0–62–127 00–7F 06
# Rate 0.05–2.05–10.0 *6 07
Depth 0–72–127 00–7F 08
Polarity Down/Up 00/01 09
Low Gain -12–0–+12 34–4C 13
Hi Gain -12–0–+12 34–4C 14
Pan L63–0–R63 00–7F 15
Level 0–96–127 00–7F 16
To Next Page
Loading...
Need help?
General
