51
About Parts and Parameters
The Functions of Parameters Set
Individually for Each Part (Edit screen)
Parameters for individual parts are set in the Edit screen. The Edit screen contains
nine groups of parameters: EFFECT, EDIT, MODIFY, S.TUNE, MOD, BEND, CAF,
CC1, and U.INST. Use the following procedure to make settings.
■ Procedure
1
To set parameters for an individual part, make sure that the Part Basic
screen
is selected, and then press PART [ ] or [ ] to select the part.
2
Press [EDIT].
The edit screen will appear.
fig.5-2
3
Press [F1] – [F4] to select from the following parameter groups.
[F1] [F2] [F3] [F4]
EFFECT EDIT MODIFY →
S.TUNE MOD BEND →
CAF CC1 U.INST →
For details about each parameter, refer to What Each Parameter Does (p.54).
4
Press VAR. [ ] or INST [ ] to move the cursor up and down, and select
the parameter you want to modify
5
Rotate the [VALUE] knob, or press [DEC] or [INC] to set the value for the
parameter.
6
When you finish making settings, press [EXIT] to end the procedure.
The Edit screen refers to
the state when [EDIT] is
pressed in the Part Basic
screen.
For details on the U.INST
parameters, refer to
Creating and Saving a
Sound (User Instrument)
(p.67).
Part Basic screen (p.29)
After pressing the [EDIT]
utton in step 2, you can
also switch part status by
simultaneously pressing
oth the PART [ ] and
[ ] buttons (ALL).
Pressing [→] ([F4]) scrolls
the screen to the next.
After you have finished
setting the value in step 5,
you can simultaneously
press [DEC] and [INC] to
transmit the currently
displayed parameter value.
(p.135)
To Next Page
Loading...
Need help?
General
