13—Operating the Hard Disk Recorder
190 www.rolandus.com Roland VS-2480 Owner’s Manual
Clearing Markers
Clearing a Marker Using PREVIOUS and NEXT
1. Move to the marker you want to clear using PREVIOUS or NEXT (see Page 189).
2. Hold down CLEAR and press TAP.
Clearing a Marker in the Clear Marker Window
1. Press MARKER—the Locate to Marker window appears.
2. Turn the TIME/VALUE dial to place an arrow to the left of
the desired marker.
3. Press CLEAR—the Clear Marker window appears.
4. Turn the TIME/VALUE dial to select another marker if you
want to.
5. Press ENTER/YES to clear the selected marker.
6. Press EXIT/NO to leave the Clear Marker window.
7. Press EXIT/NO to close the Locate to Marker window.
Clearing All Markers at Once
1. Hold down SHIFT and CLEAR and press TAP. The VS-2480 asks if you’re sure you
want to delete all of the project’s markers.
2. Press ENTER/YES to clear all markers from the project, or EXIT/NO to cancel the
operation.
Editing Markers
The UTILITY menu’s Marker screen provides tools for naming, clearing, resetting or
jumping to any marker.
1. Hold down SHIFT and press MARKER.
2. Press
or
or turn the TIME/VALUE dial to select the marker you want to edit.
You can:
• Press F1 (NAME) to rename (Page 73) the selected marker.
• Press F2 (CLEAR) to delete the selected marker.
• Press F3 (GetNow) to reset the marker to the timeline’s current position.
• Press F4 (GO TO) to move the timeline to the selected marker’s position.
3. Press F6 (EXIT) when you’re done to confirm your changes.
In addition to the two methods listed here, you can clear a marker in the UTILITY
menu’s Marker screen, described in “Editing Markers” below.
When you clear all markers, every marker in the project is deleted, including all CD
track markers.
VS2480OMUS.book 190 ページ ２００６年２月７日 火曜日 午後４時１６分
To Next Page
Loading...
Need help?
General
