21—Using the Phrase Pads
286 www.rolandus.com Roland VS-2480 Owner’s Manual
Bouncing Phrase Sequence Tracks
1. If you’re not in Phrase Sequence mode, hold down SHIFT and press PHRASE PAD
PLAY•PHRASE SEQ so that it lights solid red to indicate that the phrase sequencer
is ready to play back its data.
2. Make sure that the PHRASE SEQ STATUS button for any sequence track you want
to bounce is green.
3. If you want to change any CH EDIT settings for a sequence track—including
adding effects or linking the sequence track to its odd/even partner—hold down
SHIFT, press its CH EDIT button and make the desired changes. If you’re adding
effects, make sure to route the FX return channels to your destination hard disk
recorder tracks, and bring up the necessary FX return channel faders.
4. If you want to change the destination V-Track for any of your destination hard disk
recorder tracks—or if you want to link the track to its odd/even partner—hold
down SHIFT, press the desired track channel’s CH EDIT button and make the
desired changes.
5. Route the source sequence tracks to the destination hard disk recorder tracks as
you would for a normal bounce—the sequence tracks look just like standard tracks
on the Quick Routing screen and in the EZ ROUTING VIEW screen.
6. Arm each destination track for recording by holding down REC and pressing the
track’s TRACK STATUS button.
7. Hold down REC and press PLAY to perform the bounce.
8. When the bounce is complete, hold down SHIFT and press PHRASE PAD
PLAY•PHRASE SEQ to leave Phrase Sequence mode.
9. Hold down STOP, press TRACK STATUS for your destination tracks and listen to
the bounce.
VS2480OMUS.book 286 ページ ２００６年２月７日 火曜日 午後４時１６分
To Next Page
Loading...
Need help?
General
