21—Using the Phrase Pads
Roland VS-2480 Owner’s Manual www.rolandus.com 283
Micro-Editing Sequencer Data
On the first PHRASE SEQUENCE screen, press F4 (MICRO) to view the MICRO EDIT
screen. On this screen, you can manually change the start time and the length of each
sequenced phrase. You can also delete phrases on this screen.
To view the desired track’s sequenced data, press F1 (Tr Inc) or F2 (Tr Dec) to move
higher or lower, respectively, through the phrase sequencer’s list of sequence tracks.
The current track’s name and data is shown above the list of its phrases.
To change a phrase’s:
•
start time
—press
or
to select the phrase in the list. Use
and
to select the
desired unit of time measurement in the Start column—you can select time code or
measures/beats/ticks. Turn the TIME VALUE dial to select the desired start location.
•
length
—press
or
to select the phrase in the list. Use
and
to select the
desired unit of time measurement in the Duration column—you can select time
code or measures and beats. Turn the TIME VALUE dial to set the phrase’s length as
desired.
To delete a phrase:
1. Press
or
to select the phrase in the list.
2. Press F4 (DELETE) to erase the phrase.
To undo a micro-edit:
1. Press F5 (UNDO). Until you perform a new edit or sequence more data, you can
press F5 (REDO) to reverse the undo.
To leave the MICRO EDIT screen, press F6 (EXIT).
You can see the changes you make in the data window above the phrase list.
VS2480OMUS.book 283 ページ ２００６年２月７日 火曜日 午後４時１６分
To Next Page
Loading...
Need help?
General
