Siemens SIMODRIVE POSMO A User Manual

3
3.2 Commissioning the DP master
3-79
E Siemens AG 2013 All Rights Reserved
SIMODRIVE POSMO A User Manual (POS1) – 08/2013 Edition
3.2.3 Parameterizing and start–up tool ”SimoCom A” (from SW 1.5)
A PG/PC is required to install the tool; it must fulfill the following minimum
requirements:
S Operating system:
Windows XP
®
Windows Vista
®
Windows 7
®
S 32 MB RAM memory
S 30 MB free memory on the hard disk
The ”SimoCom A” parameterizing and start–up tool is available through
the Internet as follows:
S German
http://support.automation.siemens.com/WW/view/
de/10804026/133100
S English
http://support.automation.siemens.com/WW/view/
en/10804026/133100
The ”SimoCom A” parameterizing and start–up tool can be used for all
SIMODRIVE POSMO A drives from SW 1.5 onwards.
The functional scope of the ”SimoCom A” tool is continually adapted to
the expanded functionality of these drives.
In order to parameterize and handle all of the functions of a drive using
”SimoCom A”, the optimum matching ”SimoCom A” must be used. This
depends on the drive software release.
Reader’s note
Which version of ”SimoCom A” optimally matches which drive and
which drive software release?
Refer to ”SimoCom A” as follows:
Help ––> info about ”SimoCom A” ... ––> versions
Prerequisite
Where can I get
”SimoCom A”?
Which version is
the optimum
”SimoCom A”
version?
3 Commissioning
02.9908.0305.13

Siemens SIMODRIVE POSMO A Specifications

General

Brand	Siemens
Model	SIMODRIVE POSMO A
Category	Engine
Language	English