Description 02.00
3-28 Siemens AG 6RX1700-0AD76
SIMOREG DC Master Operating Instructions
5) Requirements:
The control stability (closed-loop PI control) is referred to the rated motor speed and applies
when the SIMOREG converter is warm The following conditions are applicable: -Temperature
changes of ±10 °K
- Line voltage changes corresponding to +10% /
– 5% of the rated input voltage
- Temperature coefficient of temperature-compensated tacho-generators 0.15‰ per 10 °K
(applies only to analog tacho-generator)
- Constant setpoint (14-bit resolution)
6) Also refer to Section 3.3 and 9.
7) Also permissible for 2AC 460 (+10% / – 20%).
3.5 Applicable standards
VDE 0106 Part 100
Arrangement of operator control elements in the vicinity of components/parts at hazardous voltage
levels.
VDE 0110 Part 1
Insulation coordination for electrical equipment in low-voltage installations.
Degree of pollution 2 for boards and power section.
Only non-conductive contamination is permissible. Occasional conductivity due to moisture
condensation must, however, be expected.
”Moisture condensation is excluded, as the components are only permitted for humidity class F."
EN60146 T1-1 / VDE 0558 T11
Semiconductor converter
General requirements and line-commutated converters
DIN EN50178 / VDE 0160
Regulations for equipping electrical power systems with electronic equipment.
EN61800-3
Variable-speed drives, part 3, EMC Product Standard including special testing procedures
DIN IEC 60068-2-6 acc. to severity grade 12 (SN29010 Part1)
Mechanical stressing
3.6 Abbreviations
CB Communications board
PKW Parameter ID value
PZD Process data
TB Technology board
ZSW Status word
To Next Page
Loading...
Need help?
General
