02.00 Installation
Siemens AG 6RX1700-0AD76 5-1
SIMOREG DC Master Operating Instructions
5 Installation
CAUTION
Failure to lift the converter in the correct manner can result in bodily injury and/or property
damage.
The converter must be lifted using suitable equipment and under the instruction of appropriately
qualified personnel.
To preclude the risk of deformation damage to the housings of converters with rated DC current
of 720A or higher, the lifting lugs used to raise them must not be subjected to any horizontal
forces.
The user is responsible for installing the converter, motor, transformer as well as other
equipment according to safety regulations (e.g. DIN, VDE), as well as all other relevant national
or local regulations regarding cable dimensioning and protection, grounding, isolating switch,
overcurrent protection, etc.
The converter must be installed in accordance with the relevant safety regulations (e.g. DIN,
VDE), as well as all other relevant national and local regulations. It must be ensured that the
grounding, cable dimensioning and appropriate short-circuit protection have been implemented
to guarantee operational safety and reliability.
Possible lifting method for converters with rated DC current of 1500A to 2000A
To Next Page
Loading...
Need help?
General
