Siemens SIMOTION D4x5-2 User Manual

Explanations for p7775
The following jobs can be issued via p7775:
1: Backup NVRAM data (on CompactFlash card)
2: Restore NVRAM data (from CompactFlash card)
3: Delete NVRAM data on CU
The acknowledgement of a job is delayed.
●
If the job cannot be executed, it is acknowledged negatively.
● If the job can be executed, it is acknowledged with the value 255.
Acknowledgements of the parameter jobs
Table 7-6 Acknowledgements of the parameter jobs
Value Cause
17 Request cannot be executed because of the operating state
20 Illegal value
107 Write access is not permitted (cause: At least one DO has a pulse enable).
As
the SINAMICS has to perform a warm restart when restoring and deleting the data, none
of the connected drives must have a pulse enable
132 Parameter change blocked (see p0300, p0400, p0922, p7760, macro being executed)
204 Write access not permitted
255 "OK": Job being executed
If an error is detected during the execution of a parameter job, the error cause is signaled via
the parameter itself (no message via the fault buffer).
Causes of errors for parameter jobs
Table 7-7
Causes of errors of the parameter jobs
Value Cause
10 Error occurred while deleting
11 No backup possible: Memory card is not inserted
12 No backup possible: Memory card is full
13 Backup could not be completed (e.g. memory card removed during the backup)
14 Restoration not possible: Memory card is not inserted
15 Restoration not possible: Checksum of the NVRAM data backup file is faulty
16 Restoration not possible: No backup available
Commissioning (software)
7.5 Additional information on configuring the SINAMICS Integrated
SIMOTION D4x5-2
236 Commissioning and Hardware Installation Manual, 03/2018, A5E33441636B

Siemens SIMOTION D4x5-2 Specifications

General

Brand	Siemens
Model	SIMOTION D4x5-2
Category	Control Unit
Language	English