See also
Downloading a project into the target system
(Page 197).
For more information on symbolic assignment, see the
SIMOTION Runtime Basic Functions
Function Manual.
7.7.3 Testing the axis with the axis control panel
Axis control panel
The axis control panel is used exclusively for testing axes. You can use the axis control panel
for the following tasks, for example:
● To test each part of the system individually before program-driven axis motions are initiated.
● In the event of an error, to test whether the individual axes and drives can be traversed
from the axis control panel
● To traverse the axes for optimization purposes (controller optimization)
● To perform active homing
● To set and remove the axis enable
● To test an axis that has been created
Requirement
The following requirements must be fulfilled for testing:
● The project has been downloaded to the target system.
● SIMOTION SCOUT is in online mode.
Commissioning (software)
7.7 Creating and testing axes
SIMOTION D4x5-2
264 Commissioning and Hardware Installation Manual, 03/2018, A5E33441636B
To Next Page
Loading...
Need help?
General
