EasyManuals Logo
Home>Siemens>Control Unit>SIMOTION D4x5-2

Siemens SIMOTION D4x5-2 User Manual

Siemens SIMOTION D4x5-2
432 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #362 background imageLoading...
Page #362 background image
The
process of importing the data to an upgrade medium can be performed at the machine
manufacturer's premises; alternatively, if the upgrade archive has been transferred to the
machine operator, the service engineer can do this on site.
The service engineer imports the upgrade data on an operator-guided basis (without any
involvement by the application engineer) to the SIMOTION device(s), and upgrades the
SIMOTION devices in the process (SIMOTION SCOUT is not required on-site).
The following describes how to upgrade a SIMOTION D with a USB stick. This assumes you
have a USB stick containing the appropriate upgrade data.
Requirement
You have a USB stick containing the upgrade data.
Note
When upgrading using a USB stick, the points listed below must be observed. The version
information refers to the firmware version on the CF card (that is, the original version from
which upgrading is to take place).
Version V4.2: Upgrading via a USB stick is not supported.
Version < V4.3 SP1 HF12: The USB stick may only be inserted when the Control Unit is
switched off.
Version V4.3 SP1 HF12: The USB stick can be inserted when the Control Unit is switched
on or off.
Procedure
When using a USB stick to perform an upgrade, proceed as follows:
1. Check
the position of the service selector switch (upper rotary switch SVC/NCK). The switch
must be in the "0" position.
2. Insert the USB stick in one of the two USB interfaces of the activated D4x5‑2 (only one
USB stick may be inserted).
3. Switch the device OFF/ON or reset it using the RESET button.
Service and maintenance
8.4 Performing a firmware and project update
SIMOTION D4x5-2
362 Commissioning and Hardware Installation Manual, 03/2018, A5E33441636B

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SIMOTION D4x5-2 and is the answer not in the manual?

Siemens SIMOTION D4x5-2 Specifications

General IconGeneral
BrandSiemens
ModelSIMOTION D4x5-2
CategoryControl Unit
LanguageEnglish

Related product manuals