Connecting a PG/PC to a SIMOTION C
You can interconnect the programming device / PC
● with the PROFIBUS of SIMOTION C (connector X8 and/or X9) using a connecting cable
(see chapter Network components for a PROFIBUS subnet (Page 122)).
Information on the respective cable lengths for PROFIBUS DP can be found in chapter
Onboard measuring system interface (C230-2, C240) (Page 56).
● to the Ethernet of the SIMOTION C (connector X7) with a shielded twisted pair cable.
For information about cabling the Ethernet subnet, refer to chapter Configuring an Ethernet
subnet on the Ethernet interface (Page 124).
● to the PROFINET interface X11 (port P1, P2 or P3) of the C240 PN with a shielded twisted
pair cable.
For information about cabling the PROFINET subnet, refer to chapter Configuring an
Ethernet subnet on the PROFINET interface (C240 PN) (Page 126).
8.2 Inserting and changing the Micro Memory Card
Procedure:
1. Switch off the power supply module.
2. Is a micro memory card inserted? If yes: remove the memory card.
An ejector is located on the frame of the module receptacle to enable you to remove the
micro memory card.
Press the ejector and remove the micro memory card.
Commissioning
8.2 Inserting and changing the Micro Memory Card
SIMOTION C
138 Operating Instructions, 11/2016, A5E33441428B
To Next Page
Loading...
Need help?
General
