Siemens SINUMERIK 828D Series User Manual

4.16.12 This is how you install an SMC40
Installing
,QVHUWDVFUHZGULYHUZLWKDZLGHEODGHWRPP
LQWKHVORWRIWKHPRXQWLQJVOLGHUURWDWHWKURXJK
rದDOWHUQDWLYHO\SXVKWKHOHDGGRZQZDUG
Figure 4-57 SMC40 installation
Procedure:
1. Place the component on the mounting rail.
2. Then, swivel the component on the mounting rail so that the mounting catches click into
place at the rear.
3. Slide the component along the mounting rail to either the left or right up to its final position.
4. Screw on the protective conductor connection.
5. Screw on the encoder connecting cables X520/x.
6. Insert the DRIVE-CLiQ cables at X500/x.
7. Insert connector X524 for the electronics power supply.
Note
The 50 mm ventilation clearances above and below the components must be observed.
Service cases - hardware
4.16 Sensor Modules Cabinet
Software and hardware
Service Manual, 08/2018, 6FC5397-5DP40-6BA1 213

Siemens SINUMERIK 828D Series Specifications

General

Brand	Siemens
Model	SINUMERIK 828D Series
Category	Control Unit
Language	English