3.7 Machine registration
Overview
The machine registration contains:
● Notification of the startup date (e.g. start of production)
● Notification of where the machine is located (final destination)
● Notification regarding the Siemens components and software versions installed
● Name of the machine OEM, the machine type and the machine number
This is how you register a machine:
● Create a machine logbook
● Create a new entry in the logbook
● Save the machine identity
● Send the machine identity
On-site service (OSS)
SINUMERIK 828D and the associated drive, motor and accessories from Siemens include an
on-site service (local service) for 24 months. The on-site service time is extended to 36 months
by registering the machine.
You can obtain additional information about the on-site service here SIOS_OSS
(
www.siemens.com/automation/oss).
Precondition
To change the end user final destination data, the following access rights must be available:
● Softkey "Manufacturer" : Access level 1 (password: Manufacturer)
● Softkey "Dealer" : Access level 2 (password: Service)
● Softkey "End user": Access level 3 (password: User)
3.7.1 This is how you generate the machine logbook
Machine data
The following data are saved in the control in the "Machine logbook":
● Contact data of the manufacturer (OEM)
● Contact data of the dealer (if available)
● Contact data of the end customer
● Log of the service and diagnostic procedures that have already been carried out.
Service cases - software
3.7 Machine registration
Software and hardware
Service Manual, 08/2018, 6FC5397-5DP40-6BA1 71
To Next Page
Loading...
Need help?
General
