Siemens SIPROTEC 7SJ62 Instruction Manual

Functions
6-1157SJ62 Manual
C53000-G1140-C121-1
Figure 6-51 Logic Diagram for Undervoltage Protection
6.11.2 Programming Settings
General Voltage protection is only in effect and accessible if address  is set to
(QDEOHG during configuration of protective functions. If the voltage protection function
is not needed, address  should be set to 'LVDEOHG.
All setting values are based on phase-to-phase voltages. The setting ranges depend
on the type of voltage transformer connection utilized (specified at address ). For
voltage transformers connected in a grounded-wye configuration, higher setting val-
ues may be used because the voltage inputs are subjected only to phase-to-ground
voltage levels.
I>
 '(/$<
T0
 %NU&ORVHG,0,1
27-2 TRIP
27-2 PU CS
„1“
 &855(17683(59
V<
 38
V<<
 3,&.83
&
or
&
&
27-2 picked up
 '(/$<
T0
&
27-1 TRIP
27-1 PU CS
&
&
27-1 picked up
&
&
„1“
 )&7
>BLOCK 27
>BLOCK 27-1
>BLOCK 27-2
or
27 BLOCKED
27 OFF
&
27 ACTIVE
0HDVXUHPHQW/RJLF
or
>27 I SUPRVSN
F# 6539
F# 6534
F# 6533
F# 6540
F# 6538
F# 6537
F# 6531
F# 6530
F# 6532
F#. 6503
F# 6508
F# 6506
F# 6505
20 ms
2))
21
2))
21
$ODUP2QO\
www . ElectricalPartManuals . com

Siemens SIPROTEC 7SJ62 Specifications

General

Brand	Siemens
Model	SIPROTEC 7SJ62
Category	Relays
Language	English