Functions
6-37SJ62 Manual
C53000-G1140-C121-1
6.1 General
A few seconds after the device is powered up, the default display will appear showing
measured values by the 7SJ62 protective relay.
The settings associated with the various device functions may be modified using the
controls on the front panel of the device or by using the operator interface in DIGSI
®
4
in conjunction with a personal computer. Password No. 5 is required to modify individ-
ual settings.
From the
Device Front
Select the 0$,10(18 by pressing the key. Using the key, select 6HWWLQJV,
and then press the key to navigate to the 6(77,1*6 display (see Figure 6-1).
In the 6(77,1*6 display, use the key to select the desired function, and then use
the key to navigate to that function (e.g., use the key to select the 36\VWHP
'DWD function, and then use the key to navigate to the 36<67(0'$7$display,
as shown in Figure 6-2.
In general, an item number appears in the menu list to the right of each selection. Nav-
igation can be accomplished using the item number in place of the and keys.
This feature is particularly helpful in large menus (e.g., setting lists). Based on the ex-
ample above, from the 0$,10(18, the 6(77,1*6 display can be accessed by press-
ing on the keypad, and then the 36<67(0'$7$ display can be accessed by
pressing on the keypad.
Figure 6-1 Example of Navigation From The Front Control Panel
Each setting contains a four-digit address number followed by the setting title as
shown in Figure 6-2. The value of the current setting is displayed in the line just below
the setting address number and title. The value may be text (Figure 6-2, setting )
or numerical (Figure 6-2, setting ).
Figure 6-2 Example of Power System Data Display
MENU
4
0 3
0$,10(18
$QQXQFLDWLRQ²!
0HDVXUHPHQW²!
&RQWURO²!
6HWWLQJV²!
7HVW'LDJQRVH²!
6(77,1*6
'HYLFH&RQILJ²!
0DVNLQJ,2²!
36\VWHP'DWD²!
*URXS$²!
36<67(0'$7$
&76WDUSRLQW
WRZDUGV/LQH
9QRP35,0
$5<
N9
www . ElectricalPartManuals . com
To Next Page
Loading...
Need help?
General