Hardware and Connections
2-8 7SJ62 Manual
C53000-G1140-C121-1
Covering Caps Covering caps are available for terminal blocks with threaded terminals. The caps en-
hance the safety of personnel by covering the terminal screws; thereby, decreasing
the likelihood of inadvertent contact with the live terminals.
The caps snap on to the terminal blocks, and can easily be removed with a 6x1-mm
screwdriver. All of the terminal block screws must be tightened to apply a cap.
There are two types of covering caps, as shown in Figure 2-7. Ordering information is
provided in Section A.1 in the Appendix.
Figure 2-7 Covering Caps for Terminal Blocks with Threaded Terminals
Covering Cap for
18 Terminal Voltage
Covering Cap for
12 Terminal Voltage
Connection Terminal Block or 8 Terminal Current
Connection Terminal Block
SIEMENS
C73334-A1-C31-1
>PCGF<
:AMP
SIEMENS
C73334-A1-C32-1
>PCGF<
:AMP
www . ElectricalPartManuals . com
To Next Page
Loading...
Need help?
General