Siemens SIPROTEC 7SJ62 Instruction Manual

Hardware and Connections
2-10 7SJ62 Manual
C53000-G1140-C121-1
inside the 7SJ62. Each common group can, for example, be used for signal replication
or as a common point for a signal (independent of the signals on the pin “a” terminals).
Depending on the version of the terminal block, 18 or 12 common connections are
available.
Grouping of common connections within a terminal block is as follows:
12 Terminal Block: Group 1 Terminals 1 through 6
Group 2 Terminals 7 through 12
18 Terminal Block: Group 1 Terminals 1 through 9
Group 2 Terminals 10 through 18
All shielding pins are connected together as shown in Figure 2-10. The shielding pins
are also connected to the rear panel of the 7SJ62. Depending on the version of the
terminal block, 18 or 12 shielding connections are provided.
Figure 2-10 Schematic Diagram of the Plug-in Terminal Blocks
Connections to
Plug-In Terminals
Connections to plug-in terminals are made with pin connectors.
There are two versions of pin connectors:
Version 1: 2-pin connector
Version 2: 3-pin connector
Signal Connection
Common Connection
Shielding Connection
Common Connections, Group 1
Looped Together
Common Connections, Group 2
Looped Together
Shielding Connections
Looped Together
cba
abc
abc
abc
abc
abc
abc
cba
cba
cba
cba
cba
2
3
4
5
6
7
8
9
10
11
12
1
cba
abc
abc
abc
abc
abc
abc
cba
cba
cba
cba
cba
2
3
4
5
6
7
8
9
10
11
12
1
abc
abc
abc
cba
cba
cba
13
14
15
16
17
18
12 Terminal 18 Terminal
www . ElectricalPartManuals . com

Siemens SIPROTEC 7SJ62 Specifications

General

Brand	Siemens
Model	SIPROTEC 7SJ62
Category	Relays
Language	English