8.7.4 Current zero tracking weight
The current zero tracking weight is recorded in this parameter if automatic zero tracking is
activated.
8.7.5 Dead load
The characteristic curve of the scales is determined during calibration. When there is no load,
the main display returns "0". The dead load is the weight of the empty scales, i.e. the weight of
the scales themselves.
8.8 DR 6 limit value settings
The switch-on and switch-off values for the limits are configured in data record DR 6.
Procedure
● Check all parameters and modify them as required
● Transfer the data record to the scale
Table 8-4 Assignment of data record 6
Variable Note Type L Rw Default Min. Max.
Data record num‐
ber
Contains no. of data record UINT 2 r 6 - -
Length Data record length information UINT 2 r 60 - -
Application Information on which application the
DR belongs to
UINT 2 r 201 - -
Version identifier Information on the current data record
version
UINT 2 r 1 1 65 635
Limit reference
(Page 74)
Reference value for limits
0: Gross weight in % of max. weighing
range
1: Net weight in % of max. weighing
range
2: Gross weight, absolute
3: Net weight, absolute
UINT 2 rw 0 0 1
Reserve Reserve UINT 2 rw 0 0 -
Limit value 1 ON
(Page 75)
Switch-on point for Limit 1 REAL 4 rw 0 maxi‐
mum
number
range
maxi‐
mum
number
range
Reserve Reserve TIME 4 rw 0 0 maxi‐
mum
number
range+
Scale parameters and functions
8.8 DR 6 limit value settings
SIWAREX WP321
Operating Instructions, 08/2019, A5E33715669A-AD 73
To Next Page
Loading...
Need help?
General
