Operator error (code 1000 to 1999) Error code Description and remedy
1102 ADU error 1102 AD converter error when reading in the measured value. If the
error occurs again, make sure that the EMC recommendations
are observed (chapter EMC-compliant setup (Page 22)).
1104 Undervoltage 1104 Undervoltage at sensor cables
1105 Overload 1105 Overload of scale (ca. 110%)
1106 Underload 1106 Underload of scale (ca. -10%)
1110 No communication with SIWAREX DB 1110 No communication with SIWAREX DB
9.5.2 Technology error message list
Technology error (code 2000 to 4999) Error code Description and remedy
2000 Technology error exists 2000 Group message, at least one technology error exists
2001 Taring/zeroing timeout 2001 Taring of scale or set to zero is not possible because a standstill was
not reached during the standstill time. The command was discarded.
2005 Reboot after power reset 2005 Reboot after voltage recovery or FW update
9.5.3 Data and operating errors message list
Data and command errors
(code 5000 to 8999)
Error code Description and remedy
5000 Data or comand error exists 5000 Group error, a bit is set in the data and operating error bits
5001 Data record or comand unknown 5001 Command code or data record is not known with current appli‐
cation
5003 Cannot exit service mode 5003 Cannot exit service mode; calibration incomplete
5004 Command or data transfer only per‐
mitted in service mode
5004 Activation of service mode is required to execute command or
transmit data
5005 Command or data transmission not
possible because service mode is active
5005 Command can currently not be executed because service
mode is active
5006 Command or data transfer not possi‐
ble while BUSY
5006 Command can currently not be executed because module is
BUSY (data record or command transmission already active,
…)
5007 Command or data transmission not
possible because module is faulty or SI‐
MATIC CPU stop
5007 Command can currently not be executed because of a problem
or SIMATIC CPU stop
5101 Command is not permissible in this
operating state
5101 Command is not permissible in the current operating state
5102 Comand not possible while not stand‐
still
5102 Scale command (set to zero, tare, log, … ) cannot be executed
because standstill is missing.
5104 Command not possible while limit ex‐
ceeded
5104 Command (e.g. set to zero, tare, calibrate command) cannot
be executed because the permitted range has been exceeded.
5105 Load cell parameters not plausible 5105 Load cell parameters in data record DR 10(a) or data record
DR 11(d) not plausible (number, supporting points, load spec‐
ifications, etc.).
Messages
9.5 Message list
SIWAREX WP321
Operating Instructions, 08/2019, A5E33715669A-AD 99
To Next Page
Loading...
Need help?
General
