Variable Note Type L Rw De‐
fault
Min. Max.
Reserve - BIT r 0 0 1
2000 Technology error BIT r 0 0 1
2001 Taring or zeroing timeout BIT r 0 0 1
Reserve
(3 bits)
- BIT r 0 0 1
2005 Cold restart after voltage recovery BIT r 0 0 1
Reserve
(10 bits)
BIT r 0 0 1
5000 Data or operating error exists BIT r 0 0 1
5001 Command code or data record unknown BIT r 0 0 1
Reserve - BIT r 0 0 1
5003 Leaving calibration mode not possible BIT r 0 0 1
5004 Command or data transmission only
available in service mode
BIT r 0 0 1
5005 Command or data transmission not pos‐
sible because service mode is active
BIT r 0 0 1
5006 Command or data transmission not pos‐
sible because BUSY
BIT r 0 0 1
5007 Command or data transmission not pos‐
sible because module is faulty or ODIS is
active
BIT r 0 0 1
Reserve - BIT r 0 0 1
Reserve - BIT r 0 0 1
5101 Command is not permissible in this oper‐
ating state
BIT r 0 0 1
5102 Command not possible because not at
standstill
BIT r 0 0 1
5104 Command not possible because range is
exceeded
BIT r 0 0 1
5105 Load cell parameter not plausible BIT r 0 0 1
Reserve BIT r 0 0 1
5107 Shifting characteristic not possible BIT r 0 0 1
7000 Permitted number range violated BIT r 0 0 1
Reserve - BIT r 0 0 1
Reserve - BIT r 0 0 1
7002 Specifications of string lengths not plau‐
sible
BIT r 0 0 1
Reserve - BIT r 0 0 1
Reserve - BIT r 0 0 1
7006 Command only possible in test field BIT r 0 0 1
7007 The calibration weights or calibration dig‐
its are not plausible
BIT r 0 0 1
7008 Zeroing/zero setting or tare parameter
not plausible
BIT r 0 0 1
Scale parameters and functions
8.16 DR 32 Message display
SIWAREX WP321
Operating Instructions, 08/2019, A5E33715669A-AD 89
To Next Page
Loading...
Need help?
General
