User Manual
EM303A General Purpose Inverter
88
No.
Function
Range Unit
Default
Type
F0-28 Default Control
0: Disabled
1: Defaults Reset
0 〇
F0-29 Parameter Setting Control
0: Parameter setting permitted
1: Parameter lock 0
2: Parameter lock 1
0 ●
Reset Default
F0-28=1 Reset Default: Except motor parameters in Group F1 and FA, inverter
parameter in Group Fd, and F4-28 application macros, the parameters will
reset to default. After reset completed, F0-28=0.
Parameter Lock
F0-29=0 All parameters are allowed to be edited.
F0-29=1Parameter lock 0:
Lock parameters except numeric settings. The numeric settings are primary
numeric frequency setting F0-07, auxiliary numeric frequency setting F9-06,
jog running frequency F0-11, preset speed 1~15(F3-00
～ F3-14), PID
numeric setting F4-01, preset PID setting 1~7(Fb-20
～ Fb-26), numeric
torque current F5-12, and preset torque setting 1~7(F5-15
～F5-21).
F0-29=2Parameter locked 1:
Lock all parameters except F0-29. Inverter will remain the setting before
unlocked.
No.
Function
Range
Unit Default
Type
F0-30
Inverter Model
0: Model G 1: Model P
0
〇
F0-30=0 Set inverter as Model G which is applicable to mechanical or constant torque
load.
F0-30=1 Set inverter as Model P which is applicable to square or cubic torque load
like blower, and water pump.
★ Set inverter as Model P, applicable motor power detailed on the Nameplate.
Note: The constant torque load is not applicable to Model P.
No.
Function
Range Unit
Default
Type
F0-31 User Password
0～65535 XXXX 〇
F0-31 Set a new password to start password protection and prevent unqualified
personnel from editing the inverter parameters incorrectly. When password is
0, the password function is disabled.
7.2 Group F1: Motor Parameters
No.
Function
Range
Unit Default
Type
F1-00 Motor Type
0: AC induction motor
1: Not used
0 〇
F1-01 Motor Rated Power 0.40～480.00 kW XXXX 〇
F1-02 Motor Rated Voltage 60～660 V XXX 〇
To Next Page
Loading...
Need help?
General