Service Manual
Original issue
Feb. 2007
Page 21/55
Model
CE-200E
14. Feed timing ( horizontal movement )
１．Set test mode A and set straight stitch at maximum stitch length.
２．Set feed-dog at the start of its movement (when feed cam starts to activate
forked connection rod)
３．Turning hand wheel, bring up needle to its highest dead position.
４．Check if total lateral movement of feed-dog during the period from Step 2 to
Step 3 above is within the range of 0.1mm – 0.1.5mm.
0.1 to 0.15ｍｍ
Needle at highest position
Main shaft
To Next Page
Loading...
Need help?
General
