Steris InnoWave Unity User Manual

6.1 Selecting a Wash Program
The wash program that the sonic irrigator uses for the next wash cycle is shown on the
LoadInstruments screen. The sonic irrigator defaults to the wash program last used: to
select a different wash program, follow the procedure below.
1. From main menu, touch or repeatedly until the wash program symbol is
centered and Select Program appears above it.
2. At the bottom of the screen, touch to cycle up through wash programs, or touch
to cycle down through wash programs. Cycle through wash programs until the
desired wash program appears on the display below the wash program symbol. For
details of available wash programs, see Wash Programs on page101.
3. After selecting the desired wash program, touch or repeatedly until the start
cycle symbol is centered and Load Instruments appears at the bottom of the
screen. Confirm that the name of the desired wash program is shown below the
start cycle symbol.
50 PERFORMING A WASH CYCLE
InnoWave Unity & Unity 20 Operator Manual

Steris InnoWave Unity Specifications

General

Brand	Steris
Model	InnoWave Unity
Category	Medical Equipment
Language	English